(A). The FCC does not want those who have abused the Amateur Radio system enough to where their amateur license has been revoked to have an opportunity to use the system. Do not allow such individuals to make third party communications from your station.

Refer to FCC Part: [97.115(b)(2)]

Last edited by axis223. Register to edit

Tags: third party rules and regulations arrl module 8 arrl chapter 3

Although Technician class operators may operate SSB within the range 28.3MHz and 28.5MHz, the FCC prohibits repeater operation on this segment. The permissible segments for operating a repeater on the 10 meter radio band are only open to operators with a General Class license or above. However, a 2 meter signal from a Technician class operator may be RE-transmitted by a General Class operator using a 10 meter repeater. In this case both operators hold the frequency band privileges for the band on which they are transmitting.

Refer to FCC Part: [97.205(a) and 97.205(b)]

Last edited by gconklin. Register to edit

Tags: 10 meter general class 2 meter repeater arrl module 8 arrl chapter 3

An automatically controlled digital station means a station that is unattended, and which transmits in data modes (RTTY, etc) on frequencies that are allocated for data emissions.

The interrogating station must be under local or remote control. In other words, it cannot be interrogated by another automatically controlled station.

Third-party traffic is perfectly acceptable, provided that it follows the rules for third-party messages.

There is no restriction as to what license class the control operator of the interrogating station can have.

Refer to FCC Part: 97.221

Last edited by jeff00seattle. Register to edit

Tags: arrl chapter 6 arrl module 26

(D). Amateur Radio operators should ALWAYS take steps to avoid causing interference. All of the choices listed above are cases where special steps must be taken to make sure that the station is not causing harmful interference.

Refer to FCC Part: [97.13(b), 97.311(b), 97.303]

Last edited by N8GCU. Register to edit

Tags: harmful interference rules and regulations arrl chapter 3 arrl module 8

(C). Third parties in another country should use communication means to which their country allows them. The FCC does let U.S Amateur radio operators convey such third party communications only if they relate to Amateur radio, are remarks of a personal character, or messages relating to emergencies or disaster relief.

Refer to FCC Part: [97.115(a)(2), 97.117]

Last edited by N8GCU. Register to edit

Tags: international third party rules and regulations arrl module 8 arrl chapter 3

There are 3 ITU regions (so Region 4 is out)

Region 1: Europe, Africa, the former USSR, Mongolia, and the Middle East west of the Persian Gulf, including Iraq.

Region 2: The Americas including Greenland and some Pacific Islands

Region 3: the parts of Asia not formerly part of the USSR and most of Oceania

https://en.wikipedia.org/wiki/ITU_Region

Silly memonic: North and South America are TWO continents

Last edited by marqtheham. Register to edit

Tags: arrl chapter 3 arrl module 6

Amateur stations (with very few exceptions) cannot communicate with non amateur stations. If you intend to operate a Wi-Fi network using Amateur Radio rules, you must follow all of them including rules on whom and what (no encryption).

Last edited by amdesoto. Register to edit

Tags: arrl chapter 3 arrl module 8

Wi-Fi (IEEE 802.11 standards) is spread spectrum, so the 47 CFR 97.313(J) limit of 10 watts on a spread spectrum emission applies.

https://en.wikipedia.org/wiki/Spread_spectrum

Silly Hint: Spread the Ten!

Last edited by olivejohn147. Register to edit

Tags: arrl chapter 3 arrl module 9

Beacon stations are located around the world and are a great resource for testing your own propagation and band conditions. So avoid transmitting so you do not interfere with the beacon system.

While there are many beacons out there, the specific global beacon system referenced in this question belongs to the International Amateur Radio Union (IARU), and is well-accepted by all regions, all operators:

https://www.iaru.org/on-the-air/beacons/

Additional beacons operate just above 28.200 MHz and normally are coordinated by regional IARU Beacon Coordinators. Except for short-term experiments such as observation of the effects of solar eclipses the IARU does not support the operation of amateur beacons below 14 MHz because of congestion in these bands.

Last edited by kj275. Register to edit

Tags: arrl chapter 3 arrl module 8

This is a question about Part 97, § 97.221 Automatically controlled digital station. You should at least read Part 97 once. But, in case you don't recall, here's the entire text: (a) This rule section does not apply to an auxiliary station, a beacon station, a repeater station, an earth station, a space station, or a space telecommand station.

(b) A station may be automatically controlled while transmitting a RTTY or data emission on the 6 m or shorter wavelength bands, and on the 28.120-28.189 MHz, 24.925-24.930 MHz, 21.090-21.100 MHz, 18.105-18.110 MHz, 14.0950-14.0995 MHz, 14.1005-14.112 MHz, 10.140-10.150 MHz, 7.100-7.105 MHz, or 3.585-3.600 MHz segments.

(c) Except for channels specified in § 97.303(h), a station may be automatically controlled while transmitting a RTTY or data emission on any other frequency authorized for such emission types provided that:

(1) The station is responding to interrogation by a station under local or remote control; and

(2) No transmission from the automatically controlled station occupies a bandwidth of more than 500 Hz.

Hint: The longest answer is the right one

Last edited by a1n2d3r4e5w6. Register to edit

Tags: arrl chapter 6 arrl module 26

There are no additional restrictions place on third party messages simply because they are being transmitted remotely. A way to remember this is knowing that you always must follow FCC rules, so just look for "FCC Rules"

Last edited by dylan karpf. Register to edit

Tags: none